H264 HD Video Server and Decoder with HDMI inputs and outputs
The ANT-32000 is a High Definition H.264 video and audio CODEC that can be used in several ways. Offering Full HD video and audio encode decode and full duplex mode this is an industry first!
Firstly it can be used as al High Definition (HD) IP video server where video and audio sources are connected to it and the unit is connected to a network. Any PC that can reach it over the network can view the HD Video, listen to the audio and access all of its control features either using the supplied CMS (Central Management Software) or via a browser.
Secondly two units can be set up as an encoder / decoder pair. The signals (HDMI video, audio & control) arriving at the encoder will be decoded by the decoder. This is ideal for transmitting high quality video between 2 points in a building which has already had a network installed or between remote locations which are connected to the internet. Each unit can act as both an encoder and decoder allowing a 2 way video / audio link.
Finally the unit can be used as a decoder paired with any of the H.264 static cameras or the range of H.264 speed dome cameras sold by Antrica.
When used as an encoder or server the unit features a USB port allowing the attachement of a USB flash drive for local recording. The ANT3100 can record locally on loss of network, detected movement or on a local signal. Video can be pre-recorded before the event and can be retrieved remotely via a browser.
Features:
- HDMI input and Output ports
- High quality1920 x 1080 low bit rate H.264 video codec
- HD and SD video supported
- Video over IP via 10/100 Ethernet or WLAN
- Static or dynamic IP -DHCP, PPPoE
- One to One or one to many transmission Multicasting
- Serial port, USB port, sensor/alarm I/O
- Encode, decode or duplex mode
- Standalone end to end video over IP
- Video server to NVR or PC mode
- Motion detection
- 32kbps ~ 4Mbps
- Automatic adaptive rate control for network bandwidth
Benefits:
- Highest quality video at lowest data rates using H264 gives clearer images at low bit rates
- End to end option allows for simple camera and monitor systems without need for a PC/ NVR
- Video server allows user greater choice of wide range of analogue cameras
- Local USB recording to flash/ hard disk guarantees images are stored in case of network failure
- Local USB hard disk can be accessed over network
- Duplex mode allows for 2 way video systems
- Simple configuration over IP reduces installation time on site and allows for reconfiguration realtime
- One ANT-32000 can be used in any IP network application for encode decode or 2 way transmission
Detailed Specification
| Section | Specification | Description | |
| System | Operation System | Embedded Linux | - |
| Main Memory | 128Mbyte DDR2 | - | |
| Flash | 128Mbyte NAND FLASH | - | |
| Video | Algorithm | H.264/JPEG Encoding/Decoding | H.264/AVC MP/L4 |
| Input | 1 x HDMI type A, HDMI RX | - | |
| 1 x BNC, Composite or HD SDI | HD SDI : option | ||
| Output | 1 x HDMI type A, HDMI TX | - | |
| 1 x BNC, Composite or HD SDI | HD SDI : option | ||
| Resolution | 1920x1080/30p ~ CIF/30fps | 18 resolution steps | |
| Bitrate | 32kbps ~ 10 Mbps | ||
| Audio | Algorithm | G.711 | - |
| Input | 1 x 3.5mm JACK, LINE IN | Single Mono | |
| Output | 1 x 3.5mm JACK, LINE OUT | Single Mono | |
| Sample Rate | 8 kHz | - | |
| Bitrate | 64kbps | - | |
| Alarm/Sensor | Sensor Input | 2 x Input (3 x Terminals) | Default NO, 2 x Sensor In, 1 x GND |
| Alarm Output | 2 x Output (4 x Terminals) | Default NO, 2 x NO, 2 x COM | |
| Network | RS232 | 1 x Port (3 x Terminals) | |
| RS422/485 | 1 x Port (4 x Terminals) | Camera PTZ Control | |
| LAN | 1 x RJ45, 10/100M Ethernet | - | |
| Storage | External Backup | 1 x USB 2.0 Interface | - |
| Security | Yes | - | |
| Event | Motion detection | Yes | - |
| Sensor | Yes | ||
| Pre/post alarm | Yes | - | |
| Camera control | PTZ | Various Protocol supported | - |
| Preset | Supported for specific camera | - | |
| Notify | Alarm / E-mail | - | |
| Network | TCP/IP, Multicast, HTTP, SMTP, FTP, DHCP, DNS, Dynamic DNS, RTP, RTSP | - | |
Language |
Korean/English | - | |
| Power | Input | 2.5ΦPower Jack, 12V/0.5A | |
| External Power Adaptor | Output :12V/1.5A, Input : AC100V~220V | - | |
| PoE | 802.3af Compatible | - | |
| Certification | Domestic : MIC, Overseas: RoHS, CE, FCC | ||
| General | 4 x System Status LED | POWER/STATUS/LINK/TRX | |
| 2 x PHY Status LED | PHY LINK/100M | ||
| 1 x Default Setting Button | - | ||
VIDEO & PC SERVER DECODERS
NETWORK CAMERAS-HD MPixel
NETWORK CAMERAS- PAL/NTSC
SOFTWARE
True CMS multi viewing/ control
SYSTEMS & SOLUTIONS
Please fill out the form below to download our catalogue.