Antrica

ANT-3100 H264 Video Server and Decoder

The ANT-3100 is an H.264 video and audio CODEC that can be used in several ways.

Firstly it can be used as a traditional IP video server where video and audio sources are connected to it and the unit is connected to a network. Any PC that can reach it over the network can view the video, listen to the audio and access all of its control features either using the supplied CMS software or via a browser.

Secondly two units can be set up as an encoder / decoder pair. The signals (video, audio & control) arriving at the encoder will be decoded by the decoder. This is ideal for transmitting high quality video between 2 points in a building which has already had a network installed or between remote locations which are connected to the internet. Each unit can act as both an encoder and decoder allowing a 2 way video / audio link.

Finally the unit can be used as a decoder paired with the ANT 230 H.264 static camera or the ANT 270 range of H.264 speed dome cameras.

When used as an encoder or server the unit features a USB port allowing the attachement of a USB flash drive for local recording. The ANT3100 can record locally on loss of network, detected movement or on a local signal. Video can be pre-recorded before the event and can be retrieved remotely via a browser.

Features:

High quality low bit rate H.264 video codec
Video over IP via 10/100 Ethernet or WLAN
Static or dynamic IP -DHCP, PPPoE
One to One or one to many transmission Multicasting
Serial port, USB port, sensor/alarm I/O
Full resolution PAL or NTSC plus Audio , 1/2D1, CIF
Encode, decode or duplex mode
Standalone end to end video over IP
Video server to NVR or PC mode
Motion detection
32kbps ~ 4Mbps
Automatic adaptive rate control for network bandwidth

Benefits:

Highest quality video at lowest data rates using H264 gives clearer images at low bit rates
End to end option allows for simple camera and monitor systems without need for a PC/ NVR
Video server allows user greater choice of wide range of analogue cameras
Local USB recording to flash/ hard disk guarantees images are stored in case of network failure
Local USB hard disk can be accessed over network
Duplex mode allows for 2 way video systems
Simple configuration over IP reduces installation time on site and allows for reconfiguration realtime
One ANT-3100 can be used in any IP network application for encode decode or 2 way transmission

Detailed Specification

Video Codec

- H.264 baseline encode, decode and duplex
- Bitrate 32kbps~4Mbps
- 25/30 frames/sec at full D1 (720x480, 720x576)
- PAL or NTSC
- Intelligent bit rate control CBR / VBR
- Motion detection - region + sensitivity

Video Input

- Connector type : BNC connector
- Composite video : PAL, NTSC
- Input signal level : 1Vpp, 75ohm
- Auto Detection PAL and NTSC

Video Output

- Connector type : BNC connector
- Composite video : PAL, NTSC
- Output signal level : 1Vpp, 75ohm

Audio

- G.711 mono audio two way

Display

- Burn in OSD channel name on encoded frame
- Real time monitoring, record & playback

Security

- Four levels of user privilege
- ID/ password authentication

Network

- Ethernet 10/100 base-T (RJ-45)
- TCP/IP, multicast, HTTP, SMTP, FTP, DHCP PPPoE, DNS, Dynamic DNS
- 1 to N multicast, relay (cascade)

Data Inputs Outputs

- 1 RS-232C port, 1 RS-485/422 port
- 2 D1/ 2D0- 1 Beep
- Data rate 2,400~115,200 bps
- 1 internal or external USB port for recording

Software

- Web based viewing using Internet Explorer
- CMS: 32 channel live monitoring, record, search & play

Power

- DC12 volt, AC-DC 12 volt PSU supplied
- PoE support (802.3af)

Dimensions (WxHxD)

- 134 x 32 x 125mm

Temerature range

- -10 ~ 50^oC @ 95% RH

Weight

- approx 470g (exc PSU)

Name:
Company:
Email:
Tel: